31
Dimensions: 257 ⳯ 182 mm
VC-A560U (31-35)
Recording with the Timer
& Press SET.
• To programme the additional timer settings, press SET
and repeat steps @–&.
* Press MENU to finish settings.
The display shown to the left appears on the screen for 5
seconds, after which the normal screen returns.
( Press POWER to enter the timer standby mode. Be sure
that the TIMER LED indicator light up.
TURN VCR POWER OFF
FOR TIMER RECORDING.
佡
Normal
Screen
佡
佡
1/2
8/10 07 9:05
PM
10:35
PM
SP
--/-- --- -:-- -:-- --
--/-- --- -:-- -:-- --
DATE CH START STOP
--/-- --- -:-- -:-- --
佡
• If the power is interrupted for more than 5 seconds (power failure, etc.) during timer recording, the Auto Clock Setting will
reset the time after the power is returned (the POWER LED indicator will flash) but the timer settings will be cancelled.
• Numbered buttons can be used instead of ∂/ƒ to set the data.
• If the cassette ends before recording all the programmes, the VCR will stop, turns its power off and ejects the tape
automatically.
• In Step (, if POWER is pressed with no cassette inserted, the TIMER LED indicator flashes for 5 seconds indicating that
timer recording is not possible.
• In Step (, if the inserted cassette is without the erasure protection tab, TIMER LED indicator flashes and the cassette is
ejected.
• To stop timer recording, press STOP.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
• There are two timer setting screens (1/2, 2/2).
To Next Page
Loading...
