87
Appendix
Adjusting the Backlight
1 Press the DISPLAY button until the
mode screen appears.
2 Press l or m on the Operation
button to select “MENU”, then press
the centre of the Operation button.
3 Press l or m to select “EXECUTE”,
then press the centre of the Operation
button.
4 Press l or m to select O, then
press the centre of the Operation
button.
5 Press l or m to select “BACK-
LIGHT”, then press the centre of the
Operation button.
6 Press l or m to select “NORMAL” or
“BRIGHT”, then press the centre of
the Operation button.
NORMAL: For use indoors or under
moderate lighting conditions.
BRIGHT: For use outdoors under
strong lighting conditions, such
as bright daylight.
7 Press the DISPLAY button to turn off
the menu screen.
LCD SET
BACKL I GHT
LCD BRI GHT
LCD COLOUR
RETURN
VF BRIGHT
NORMAL
BRI GHT
BACKL I GHT
BRI GHT
Turning off the
Confirmation Sound
Available modes:
All modes
A confirmation sound is made when you
turn on or off the Power switch, press the
Start/Stop button, or perform other
designated operations. Use the procedure
below to turn off the confirmation sounds.
• The example screens shown are for Tape
Camera mode.
1 Press the DISPLAY button until the
mode screen appears.
2 Press l or m on the Operation
button to select “MENU”, then press
the centre of the Operation button.
3 Press l or m to select “EXECUTE”,
then press the centre of the Operation
button.
4 Press l or m to select Z, then
press the centre of the Operation
button.
5 Press l or m to select “BEEP”, then
press the centre of the Operation
button.
6 Press l or m to select “OFF”, then
press the centre of the Operation
button.
OTHERS 1
BEEP
REMOTE
DEFAULT
LANGUAGE
RETURN
ON
OFF
PHONES VOL
DEMO MODE
OFFBEEP
7 Press the DISPLAY button to turn off
the menu screen.
Note:
• If you select “OFF”, the focus confirmation
sound in Card Camera mode will turn off.
To Next Page
Loading...
