Sharp VL-NZ50U - MiniDV Compact Digital Viewcam User Manual

Basic Operations
Playback
19
Basic Operations
Playback
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
1 Hold down the Lock button
and set the Power switch to
VCR.
2 Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
3 Press m to begin playback.
Note:
• If you press the REC START/STOP button in VCR
mode, the “ ” mark appears and the
camcorder enters Recording Standby mode. If
you do not intend to record, press l to turn the
“ ” mark off, then press m to begin playback.
This will ensure your previous recording is not
erased (see page 44).
Basic Operations
Playback
To stop playback
Press l.
VOLUME
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Volume Control
When the camcorder is in VCR mode, push the
Volume control to the L or + side to increase
(1) or decrease (2) the volume.
The volume level indicator will appear on the
LCD screen during adjustment only. Once the
Volume control is released, the volume level
indicator will disappear shortly afterwards.
Volume control
Decrease
Increase
Lock button
Operation button
Power switch
Speaker
VL-NZ50U-016-021 02.2.12, 5:20 PM19

Sharp VL-NZ50U - MiniDV Compact Digital Viewcam Specifications

General

Brand	Sharp
Model	VL-NZ50U - MiniDV Compact Digital Viewcam
Category	Camcorder
Language	English