VL-PDl U
9-5-3. Main chassis assembly and slide chassis assembly assembling method
(l)Set the US mode (see the figure below).
(2)lnset-t the slide chassis side operation pins (0 tension arm, @ Tu guide arm, @ pinch lever) in the position shown
below at the main chassis.side, move the slide chassis in the arrow direction, using @ to @ as guides, insert the
loading lever operation pin into the groove of slide chassis, and install with the 4 screws.
@Tightening torque
40 & 4mN-m
(0.4 + O.O4kg-cm)
Numbers before part names are given as
a guide to the order of assembly.
When treating the sensor FPC wire, pay
attention to the part A shown in Fig. 6.
Oil application place is shown in Fig. 5.
*@Tightening torque
70 + 7mN.m
(0.7 + O.O7kg-cm)
To Next Page
Loading...
