11
Quick Start Operations
In order to check sales, you can read a sales report. Also you should reset sales data after you
practicing your cash register.
To read a sales report, you should take an X report; set the mode switch to the X/Flash position,
and press t.
To reset sales, you should take a Z report; set the mode switch to the Z/PGM position, and press
C. The sales data accumulated and the ground total (GT) is cleared.
For reading and resetting of actual sales data, please refer to Reading and Resetting of Sales
section. You should reset sales data at the end of each day to clear sales data.
Step 5 Reading/Resetting Sales Data
A102_01(E) 05.4.18 9:06 AM Page 11
To Next Page
Loading...
