Sharp XL-HP404E - Tape Recording; Recording from CD to Tape

03/10/20 XL-HP404E(A)3.fm
23
XL-HP404E
TINSEA009AWZZ
Tape Recording
! Recording from a CD (CDs)
You can record the desired CD using the CD DIRECT PLAY button.
To stop recording:
Press the (TAPE ) button.
The CD and tape will stop.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
4
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
5
Press the button.
Recording will be paused.
6
Press one of the 1 - 5 buttons to select the desired disc.
7
Within 5 seconds, press the CD DIRECT PLAY button to
start recording.
"
Recording starts from side A.
"
Recording is started from the selected CD. When the play-
back of the last track is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
"
CD playback will start approximately 7 seconds after the
tape starts.
7