Sharp XL-HP600E - Continuous Recording and Radio Recording

03/1/31 XL-HP600E(E)3.fm
23
XL-HP600E
Tape Recording
Recording from several CDs continuously:
To perform programmed recording:
To stop recording:
Press the (TAPE ) button.
The CD and tape will stop.
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
" Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
" Erasing recorded tapes
1 Press the TAPE button.
2 Follow steps 2 - 5 in "Recording from the radio".
1 Perform steps 1 - 5 in "Recording from a CD (CDs)" on page 22.
2 Press the / ( ) button to record on side A, or the button for
side B.
1 Programme discs and tracks. (See page 17.)
2 Press the button.
3 Press the / ( ) button to record on side A, or the button for
side B.
1
Tune in to the desired station. (See page 18.)
2
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
4
Press the button.
Recording will be paused.
5
Press the / ( ) button to record on side A, or the but-
ton for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)