03/1/31 XL-HP600E(E)3.fm
26
XL-HP600E
Advanced Features
Timer and sleep operation (continued)
! Sleep operation
To cancel the sleep operation:
Press the ON/STAND-BY button whilst the sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button whilst the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
Enhancing your system
The connection lead is not included. Purchase a commercially avail-
able lead as shown below.
! Listening to the playback sounds from VCR,
DVD, etc.
Note:
To prevent noise interference, place the unit away from the televi-
sion.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME (
or ) button.
(Maximum: 3 hours - Minimum: 1 minute)
"
3 hours - 5 minutes 5-minute intervals
"
5 minutes - 1 minute 1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep op-
eration finishes.
1
Use a connection lead to connect the VCR, DVD, etc. to the
VIDEO/AUX sockets.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
4
Play the connected equipment.
VCR, DVD, etc.
To the line
output sockets
Red
RCA lead
(not supplied)
White
Red White
To Next Page
Loading...
