32
XL-MP110E
Advanced Features
Enhancing your system (continued)
Subwoofer connection
When a commercially available speaker with a built-in amplifier is
connected to this unit, you can enjoy sound with emphasised bass.
Connect an RCA lead from a commercially available speaker with a
built-in amplifier to the SUBWOOFER PRE-OUT socket.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
CD player
RATED SPEAKER IMPEDANCE:
6 OHMS MIN.
AC INPUT
ANTENNA
RIGHT
RIGHT LEFT
FM
75 OHMS
AM
LOOP
VIDEO/AUX
IN
SUBWOOFER
PRE-OUT
SPEAKERS
LEFT
Speaker with a
built-in amplifier
Symptom Possible cause
The clock is not set to the
correct time.
Did a power failure occur? Reset
the clock.
When a button is pressed,
the unit does not respond.
Set the unit to the power stand-
by mode and then turn it back on.
If the unit still malfunctions, reset
it.
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires discon-
nected?
Symptom Possible cause
Playback does not start.
Is the disc loaded upside down?
Playback stops in the mid-
dle or is not performed
properly.
Does the disc satisfy the stan-
dards?
Is the disc distorted or
scratched?
Playback sounds are
skipped, or stopped in the
middle of a track.
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?
To Next Page
Loading...
