E-21
ENGLISH
XL-UH2000H
USB Memory Playback
Listening to USB mass storage device /
MP3 Player (continued)
Note:
To pause playback:
Press the
USB
button.
Auto power off function:
In the stop mode of USB operation, the main unit enters the stand-by
mode after 15 minutes of inactivity.
To remove USB memory device
Notes:
SHARP will not be held liable for the loss of data whilst the USB
memory device is connected to the audio system.
Files compressed in MP3 and / or WMA format can be played
back when connected to the USB terminal.
This USB memory’s format supports FAT 16 or FAT 32.
SHARP cannot guarantee that all USB memory devices will work
on this audio system.
USB cable are not recommended for use in this audio system as
connection to USB memory device. Use of the USB cable will
affect the performance of this audio system.
This USB memory cannot be operated via USB hub.
If “NO SUPPORT” is displayed, it means “Copyright protected
WMA file” or “Not supported playback file” is selected.
The USB terminal in this unit is not intended for a PC connection
but is used for music streaming with a USB memory device.
External HDD-storage cannot be playback via USB terminal.
In case the data inside the USB memory is large, it may take a
longer time for data to be read.
4 Select desired file to be played back by pressing the or
button. (Folder mode off)
5
Press the
/
(USB
/
) button.
Playback will start and the file name will be displayed.
Title, Artist & Album name are displayed if they are recorded in
the USB memory device.
Display content can be changed by pressing the DISPLAY button.
( ) Only appears when clock is already set.
File Name Display Title Display
Function Display Artist Display
TITLE-1 Indicator
TITLE-2 Indicator
Clock Display Album Display
TITLE-3 Indicator
( )
1 Press the USB button on the remote control. Wait until
“UNPLUG OK” appears on FL display.
2 Disconnect USB memory device from the USB terminal.
To Next Page
Loading...
Need help?
General
