Unboxing and Assembly
11
Shell
RIDE
7- Disc brakes
Disc brakes should come from the factory
pre-adjusted to the correct braking specifications.
If your front disc brake needs to be adjusted or
does not apply adequate stopping power to the
wheel, it may need to be adjusted, please find
steps as below:
i. First adjust the clearance between the right (inside) brake pad and the disc.
Use a 5mm allen wrench to move the inside pad inward toward the disc rotor till it touches the
rotor. Back off slightly until the pad does not touch the rotor surface.
ii. Next adjust the clearance between the left (outside) brake pad and the disc:
Turn the barrel adjuster located on the front brake lever clockwise to move the outside brake pad
inward until it touches the rotor. Back off slightly (1/4 turn) until the pad does not touch the rotor
surface and the wheel spins freely.
If there is contact between the brake pads and rotor after performing the above steps bring your
bike to your local dealer for adjustment.
Wheel quick release
Rotor
Cable
clamp bolt
Caliper
Cable
barrel
adjuster
To Next Page
Loading...