First steps
After registering, create your first room (or rooms), where you are going to add
and use your Shelly devices. Shelly Cloud allows you to create scenes for
automatic control of devices at predefined hours or based on other parameters
like temperature, humidity, light, etc. (with available sensors in Shelly Cloud).
Shelly Cloud allows easy control and monitoring using a mobile phone, tablet, or
a PC. Shelly Pro 2 can be grouped with other devices in the application, as well
as be set to trigger actions on other Shelly devices. Setting parameters for lights,
controlling blinds, etc., is also supported.
Device inclusion
Step 1
When the installation of Shelly is done and the power is on, Shelly will create its
own Wi-Fi Access Point (AP).
⚠WARNING! In case the device has not created its own AP Wi-Fi network with
SSID like ShellyPro2-F008D1DB58A0, please check if the device is connected
according to the User and Safety Guide, Installation Instructions. If you still do not
see an active Wi-Fi network with SSID like ShellyPro2-F008D1DB58A0, or you want
to add the device to another Wi-Fi network, reset the device. If the device has been
powered on, you have to restart it by powering it off and then again on. After that
you have one minute to press 5 consecutive times the button/switch connected to
the SW terminal. You should hear the relay trigger itself. After the trigger sound,
Shelly Pro 2 will return to AP mode. If not, please repeat or contact our customer
support at: support@shelly.cloud .
To Next Page
Loading...
Need help?
General
