Need help?Do you have a question about the Shelly Wave 1PM and is the answer not in the manual?
Detailed steps for safely installing the Z-Wave device, including wiring and precautions.
Guide on how to add the Z-Wave device to your network using SmartStart or manual methods.
Steps to remove the Z-Wave device from its network, including exclusion methods.
Instructions for performing a factory reset on the device using different methods.
Defines how the device interprets the switch or push-button input for the SW1 terminal.
Configures whether the device restores its previous state after a power interruption.
Allows scheduling automatic turn-off for the output (O1) after a specified time.
Allows scheduling automatic turn-on for the output (O1) after a specified time.
Sets the relay contact type for output O (01) as normally open (NO) or normally closed (NC).
Selects whether timers in other parameters use seconds (s) or milliseconds (ms).
Determines the minimum power change percentage to trigger a report to the gateway.
Sets the minimum time interval between sending power reports to the gateway.
Configures the device's response to Water Alarm notifications.
Configures the device's response to Smoke Alarm notifications.
Configures the device's response to CO Alarm notifications.
Configures the device's response to Heat Alarm notifications.
Parameter to initiate a factory reset remotely via the gateway settings.
Read-only parameter displaying a part of the device's serial number.
Read-only parameter displaying another part of the device's serial number.
Read-only parameter displaying a third part of the device's serial number.
Details on how the device handles and reports overheat detection events.
Details on how the device handles and reports overcurrent detection events.
Details on how the device handles and reports AC mains disconnection events.
Configuration and command classes for the root device's association groups.
To Next Page
General
