EN.
6
L: Live wire (110-240 V AC)
+: 24 - 30 V DC positive wire
GND: 24 - 30 V DC ground wire
Button:
S: S button
4.1 Installation instructions
The Device can control a various type of loads (e.g., bulbs) in one electrical circuit (up to 16 A)
and measures power consumption of the connected device (AC only). It can be retrofitted into
standard electrical wall boxes, behind power sockets and light switches or other places with
limited space.
⚠CAUTION! Danger of electrocution. Mounting/installation of the Device to the power grid has
to be performed with caution, by a qualified electrician.
⚠CAUTION! Danger of electrocution. Every change in the connections has to be done after
ensuring there is no voltage present at the Device terminals.
⚠CAUTION! Use the Device only with a power grid and appliances that comply with all
applicable regulations. A short circuit in the power grid or any appliance connected to the
Device may damage it.
⚠CAUTION! Do not connect the Device to appliances exceeding the given max. load!
⚠CAUTION! Do not shorten the antenna.
⚠CAUTION! Connect the Device only in the way shown in these instructions. Any other
method could cause damage and/or injury.
⚠CAUTION! Do not install the Device where it can get wet.
⚠CAUTION! Do not use the Device if it has been damaged!
⚠CAUTION! Do not attempt to service or repair the Device yourself!
⚠CAUTION! Before starting the mounting/installation of the Device, check that the breakers
are turned off and there is no voltage on their terminals. This can be done with a phase tester
To Next Page
Loading...
Need help?
General
