To Next PageTo Next PageWhat to do if my Sherwood Receiver has no power?
If your Sherwood Receiver isn't powering on, there could be a couple of reasons. First, ensure the AC input cord is securely connected. If it is, check the AC wall outlet by plugging in a lamp or another appliance to see if the outlet is working.
How to fix no sound on Sherwood Receiver?
If you're not getting any sound from your Sherwood Receiver, there are several things to check: * Make sure the speaker cords are properly connected. * Adjust the master volume to a suitable level. * Ensure the MUTE button on the remote is not activated. * Verify that the speakers are switched on. * Confirm you've selected the correct input source. * Check all connections between the components.
Why is the Sherwood Receiver remote control not working?
If your Sherwood Receiver remote control isn't working, the batteries may be exhausted or not loaded correctly; try replacing them. Also, make sure nothing is obstructing the remote sensor on the receiver; remove any obstacles.
How to get stations on my Sherwood RVD-6090R?
If your Sherwood Receiver isn't picking up any stations, make sure an antenna is connected. Also, ensure you're tuning to the desired station frequency. If the antenna is connected, try moving it to a different position and then retry tuning.
How to improve poor FM reception on Sherwood RVD-6090R?
To improve poor FM reception on your Sherwood Receiver, first ensure that an antenna is connected. If an antenna is already connected, try changing its position to find a spot with better reception.
Why is there no sound from the rear speakers on my Sherwood RVD-6090R?
If you're not hearing sound from the rear speakers on your Sherwood Receiver, check that a surround mode is selected and not normal stereo mode. Also, adjust the master volume and rear level to ensure they aren't too low. If you are using a monaural source, select a stereo or surround source instead. Finally, check the rear speaker setting and select the desired setting.
Why is there no sound from the center speaker on my Sherwood RVD-6090R?
If you're not getting any sound from the center speaker of your Sherwood Receiver, make sure that a surround mode is selected. Also, check that the center speaker setting isn't set to “N”. Finally, ensure that the master volume and center level are appropriately adjusted.
What to do if preset stations cannot be received on Sherwood Receiver?
If your Sherwood Receiver isn't receiving preset stations, it's possible that an incorrect station frequency was memorized; try memorizing the correct frequency. It's also possible that the memorized stations were cleared, so you may need to memorize the stations again.
How to stop hissing noise during FM reception on Sherwood RVD-6090R?
If you're experiencing a continuous hissing noise during FM reception on your Sherwood Receiver, especially with stereo broadcasts, it could be due to weak signals. Try changing the position of the antenna. Consider installing an outdoor antenna.
General| Channels | 5.1 |
|---|---|
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion | 0.05% |
| Input Impedance | 47 kOhms |
| Tuning range | AM/FM |
| Input sensitivity | 200 mV |
| Video Connections | Composite, S-Video |
| Speaker load impedance | 6Ω - 16Ω |
| Digital inputs | Optical, Coaxial |
| Speaker Impedance | 8 Ohms |
| Tuner Frequency Range | FM: 87.5 - 108MHz, AM: 522 - 1611kHz |
| Power Output | 100W per channel |
