2. Next, place a container below the oil filter A
to catch the used oil and unscrew the oil filter.
Discard the used oil and filter.
3. Coat the gasket on the new filter with a film of
clean oil. Screw the filter into place until the
gasket contacts its mating surface, then turn
the filter approximately three-quarters of a
turn by hand Don not overtighten.
4. Add the proper type and level of new oil, then
start the engine and check the filter for leaks.
Recommended Oils
FUEL FILTER
Draining the Fuel Filter
NOTE: The fuel filter should be drained after
every 100 hours of operation.
1. Make sure there is adequate fuel in the fuel
tank and close the fuel shutoff valve A (the
handle should be pointing to the“C”position.)
Remove the fuel sediment bowl B.
2. Open the fuel shutoff valve until all water has
been removed and only fuel flows from the
filter base.
3. Install the fuel sediment bowel. The Fuel
system is auto bleeding And does not require
any manual bleeding procedures.
NOTE: Valve is shown in open position.
3-8
LUBRICATION AND MAINTENANCE
To Next Page
Loading...
