What to do if my Shibaura CM214 is not charging?
If your Shibaura Tractor is not charging, it could be due to several reasons. It might be a faulty regulator or battery, in which case you should replace them. Check the V-belt tension and adjust if it's slipping. Also, inspect the wirings for any disconnections or misconnections and repair them as needed.
How to fix a Shibaura CM214 when it is not charging because of the alternator?
If your Shibaura Tractor is not charging, and the alternator assembly is the cause, it may be due to a damaged magnet, a seized object, a defective bearing, or a damaged flywheel. Replacing the alternator assembly should resolve the issue.
What to do if Shibaura Tractor is not charging because of broken stater coil?
If your Shibaura Tractor is not charging, and the stater coil is broken, the output wirings are disconnected, or the flywheel magnet field is reduced, you should replace the alternator assembly. If that doesn't work, replace the stater or repair the wirings. Alternatively, replace the flywheel.
Why does my Shibaura Tractor make an abnormal sound?
An abnormal sound in your Shibaura Tractor could be due to a seized object or a defective bearing. Remove the object or replace the bearing to resolve this.
General| Engine Power | 21 hp |
|---|---|
| Engine Type | Diesel |
| Drive | 4WD |
| Transmission Type | Gear |
| Number of Gears | 6 forward, 2 reverse |
Details model specifications, engine, body, capacity, electric units, and warning lamps.
Covers cleaning, shop cleanliness, part handling, and tool usage for servicing.
Step-by-step instructions for removing the engine from the tractor.
Detailed procedures for inspecting and servicing engine parts.
Inspection and repair of cylinder head, block, piston, rings, and pins.
Inspection and replacement of crankshaft, bearings, and related components.
Maintenance of fuel filter, governor, oil pump, oil filter, and injection pump.
Guidelines and procedures for reassembling the engine components.
Covers alternator, regulator, starting motor, IQS, thermometer, oil pressure switch, battery, solenoid, fusible link, wiring harness.
Inspection and testing of the alternator and regulator.
Procedures for disassembling, inspecting, and reassembling the starting motor.
Inspection of battery, IQS, thermometer, oil pressure switch, solenoid, and wiring.
Common engine issues, causes, remedies, and standard repair values.
Covers the main chassis components and drivetrain.
Maintenance for front axle, transmission, and HST unit.
Steps for removing and installing the front axle, transmission, and HST unit.
Service details for differential, HST unit, and V-belt systems.
Procedures for removing, disassembling, and installing the rear axle.
Covers power steering and hydraulic control valve systems.
Maintenance and repair of the power steering system.
Procedures for removing, installing, and servicing the hydraulic control valve.
Covers lift linkages, electrical units, and safety systems.
Details on electrical components and safety features.
Inspection, adjustment, and troubleshooting of safety systems.
Technical specifications and tolerances for tractor main body components.
Information specific to the mower attachments.
Steps to remove the mower gearbox assembly.
Procedures for disassembling and assembling the gearbox.
Detailed steps for gearbox component service.
Instructions for installing the gearbox onto the mower deck.
Maintenance for the bearing case unit.
Inspection, sharpening, balancing, and tightening of mower blades.
To Next Page