Shibuya H2021 - TECHNICAL DATA; Diamond Core Drilling Machine Specifications

8
5. TECHNICAL DATA
5.1 Diamond core drilling machine
When powered by a generator or transformer, the generator or transformer’s power output must be at
least 4.0 kVA (100 V), 3.5 kVA (110-120 V) or 5.2 kVA (220-240 V). The operating voltage of the
transformer or generator must always be the voltage stated on the model name plate label.
The specification may vary for country-specific versions. Please refer to the model name plate label
for details of its voltage, frequency, current and input power ratings.
Information for users as per EN 61000-3-11: Switching on causes a brief drop in voltage. Other
appliances may be negatively affected on mains supplies where conditions are unfavorable. No
malfunctions are to be expected in mains supplies with an impedance of less than 0.162 ohms
(220-240 V).
Motor Model H2021
Rated Voltage (V) 100 110 / 110-120 220-240
Rated Frequency (Hz) 50/60
Rated Input (W) 2700 2300 3450
Rated Current (A) 27 20 15
Spindle Rev. at No Load (min
-
1
) 470/1050 450/950 550/1200
Spindle Rev. at Rated Load (min
-
1
) 320/720 310/680 300/730
Spindle Thread UNC 1 1/4” or A-ROD
Weight (
incl. C
arri
a
g
e B
l
ock
excl. Plug and Cord)
(kg) 12.2 (26.9 lbs.)
NOTE
Never use the machine at the place where the ambient temperature is below 0 degrees C (32 degrees
F) or above 40 degrees C (104 degrees F).
Drill Stand Model
TS-255(800L/1000L) TS-255(AB52)
Max. Applicable Core Bit Diameter
w/ 30 mm Spacer
(mm) 250 (10”)
Overall Height (mm) 803 (31.6”)/1003 (39.5”) 1011 (40”)
Base Size (mm) 158 x 217 (6.2” x 8.5”) 146 x 205 (5.7” x 8.1”)
Total Stroke (mm) 493 (19.4”)/693 (27.3”) 680 (26.8”)
Max Column Tilt Angle (°) - 45
Weight (kg)
6.6 (14.6 lbs.)/
7.5 (16.5 lbs.)
7.2 (15.9 lbs.)