Shibuya H2021 - Extension Cords; SETTING UP; Fastening the Drill Stand

11
6.3 Extension cords
CAUTION
 For 220-240 V model, use only extension cords of a type approved for the application and
with conductor cross section 2 mm
2
or larger, and the maximum allowable length of the
cord is 35 meters (115 ft).
 For 110-120 V model, use only extension cords of a type approved for the application and
with conductor cross section 2.5 mm
2
(12AWG) or larger, and the maximum allowable
length of the cord is 30 meters (98 ft).
 For 100 V model, use only extension cords of a type approved for the application and with
conductor cross section 3.5 mm
2
(12AWG) or larger, and the maximum allowable length of
the cord is 30 meters (98 ft).
 Never turn on the drill motor while the extension cords are circularly bundled. The
circularly bundled extension cords may act as a coil which generates a magnetic field and
heat.
7. SETTING UP
7.1 Fastening the drill stand with an anchor
DANGER
Fasten the drill stand firmly on the material to be drilled, otherwise the machine may become
unstable during the operation and it may lead to death or serious injury to the operators and
others.
WARNING
 Read and follow the instruction manual of the anchor bolts used with the machine.
 Use anchor bolts which tensile strength is greater or equal to 24.5 kN (5.5 klbf).
 When fastening the drill stand to a wall, countermeasures must be taken to avoid falling
hazards.
 Never fasten the drill stand to a ceiling.
1) Drill a hole for Drop-In anchor, using a hammer drill.
The ideal distance between the center of the hole to be drilled and the anchor hole;
TS-255 fixed base drill stand
a) With 30 mm spacer: 300 mm (11.8”)
b) Without 30 mm spacer: 270 mm (10.6”)
TS-255(AB52) swivel base drill stand
a) With 30 mm spacer: 290 mm (11.4”)
b) Without 30 mm spacer: 260 mm (10.2”)
2) Clean out the anchor hole.
3) Insert the anchor into the hole, and hammer a setting tool to fasten the anchor firmly.
4) Screw a threaded bolt into the anchor.
5) Set the drill stand, passing the bolt through the anchor slot.
6) Insert the W3/8 square washer (standard accessory) to the bolt.
7) Insert a hex. nut to the bolt. Then, tighten the nut temporarily.
8) Adjust the leveling bolts to stabilize the base. Tighten the nut on the leveling bolts to fix the leveling
bolts firmly.
9) Tighten the hex. nut firmly using a spanner.