53
Maintenance
Charging of the satellite system ON/OFF switch
• The power can be turned ON using the power button of the (main) battery.
• The power automatically turns OFF if the bicycle is stopped for 10 minutes. When charging for
more than 10 minutes, operate any switch on the bicycle or turn the crank to prevent the
power from turning OFF.
• Connect the satellite system ON/OFF switch to a PC to charge from E-TUBE PROJECT.
This section describes how to charge the satellite system ON/OFF switch from the PC version of
E-TUBE PROJECT.
NOTICE
• To charge the satellite system ON/OFF switch from E-TUBE PROJECT, the version of
E-TUBE PROJECT must be 3.4.3 or later.
TECH TIPS
• For details, refer to the user's manual for E-TUBE PROJECT for Windows.
1. Remove the drive unit cover on the terminal block side.
The drive unit cover on the terminal block side differs according to the drive unit. Check
the dealer's manual of the drive unit for details.
Cover mounting screw
2. Connect the satellite system ON/OFF switch and the PC.
(1) Connect the electric wire of the satellite system ON/OFF switch to the PC linkage
device as shown in the figure.
To Next Page
Loading...
