https://shimano-steps.com/
226 227
https://shimano-steps.com/
E6000 MANUALE8000 CONCEPT E8000 MANUAL E6000 CONCEPT
Other
Symptom Cause / Possibility Remedy
When pressing the
switch, two beeps sound,
and the switch cannot be
operated.
Operation of the switch being pressed has been
disabled.
It is not a sign of a malfunction.
Three beeps sound. An error or warning is occurring.
This occurs when a warning or error is displayed
on the cycle computer. Refer to ”Error Message
On The Cycle Computer” (page 222) and follow
the instructions provided for the appropriate
code.
When using a electronic
gear shifting mode, I
feel that the level of
assistance weakens
when the gears shift.
This occurs because the level of assistance is
being adjusted to the optimum level by the
computer control.
It is not a sign of a malfunction.
Sound occurs after gear
shifting.
Consult us.
A noise can be heard
from the rear wheel
during normal riding.
Gear shifting adjustment may not have been
carried out correctly.
For mechanical gear shifting
Adjust the cable tension. For details, refer to the
Service Instructions for the derailleur.
For powered gear shifting
Consult us.
When you stop the
bicycle, the gear does
not shift to the position
preset in the start mode.
You may have been pressing the pedals too
strongly.
If you press the pedals lightly, the gear shifts
more easily.
Lights
Symptom Cause / Possibility Remedy
The front light or the tail
light does not illuminate
even when the switch is
pressed.
The E-tube Project settings may be wrong. Consult us.
Cycle computer
Symptom Cause / Possibility Remedy
The cycle computer is not
displayed when you push
the battery power
button.
The amount of battery charge may be
insufficient.
Recharge the battery, and then turn the power
on once more.
Is the power turned on?
Hold down the power button to turn on the
power.
Is the battery charging?
The power cannot be turned on while the
battery is mounted on the bicycle and being
charged. Stop charging.
Is the cycle computer correctly installed to the
bracket?
Install the cycle computer correctly.
Is the electric wire connector correctly installed?
Check to see if the connector of the electric wire
connecting the motor unit to drive unit is not
disconnected. If you are not sure, consult us.
A component that the system cannot identify
may be connected.
Consult us.
<SC-E6010>
The system does not start
up when you press and
hold the cycle computer
power button for 2
seconds.
Did you use the cycle computer in, or expose it
to, low temperatures for an extended period?
The cycle computer may become unable to turn on
if used in, or exposed to, low temperatures for an
extended period. Turn it on by pressing the power
button on the battery. If it still does not turn on,
consult a dealer.
Is the cycle computer correctly installed to the
bracket?
Install the cycle computer correctly.
The gear position is not
displayed.
The gear position is only displayed when the
power gear shifting unit is installed.
Check if the electric wire connector is
disconnected. If you are not sure, consult us.
Can the beep be turned
off.
Change the setting.
Refer to ”Beep Setting” (page 144).
Can the backlight be
turned off.
Change the setting.
The setting menu cannot
be launched while riding
the bicycle.
The product is designed so that if it detects that
the bicycle is being ridden, the Setting menu
cannot be launched. This is not a sign of an
abnormality.
Stop the bicycle and then make the settings.
Cycle Computer
obviously does not give
the right speed.
The correct speed depends on the proper setting
of the wheel circumference by the bike
manufacturer.
Contact us to have the correct wheel
circumference adjusted.
To Next Page
Loading...
