https://shimano-steps.com/
26 27
https://shimano-steps.com/
E6000 MANUALE8000 CONCEPT E8000 MANUAL E6000 CONCEPT
ASSIST MODE
You can select an assist mode for each particular application.
BOOST TRAIL ECO WALK
Use when powerful assistance
is required, such as when
riding up steep uphill slopes.
This mode is designed for use
on steep inclines and
precipitous mountains. When
riding on level public roads
with traffic lights, the
assistance provided may be
excessive, in which case,
switch to [ECO] mode.
Use when an intermediate
level of assistance is needed,
such as when you want to
enjoy riding comfortably on a
gentle slope or level ground.
Use when you want to enjoy
long distance riding on level
ground. When pedaling is not
very strong, the amount of
assistance is reduced and
energy consumption is lessened.
This mode is particularly
useful when walking the
bicycle, taking the bicycle out
up an incline or when it is
bearing a heavy load. It is also
useful when walking the
bicycle across uneven terrain
such as rocky areas.
When the battery level is running low, the level of assistance is lowered to increase the traveling range.
OFF
This mode does not provide power assistance when the power is turned on. Since there is no power consumption associated
with the power assistance, it is useful for reducing battery consumption when the battery is running low.
WALK
This mode is particularly useful when walking the bicycle, taking the bicycle out up an incline or when it is bearing a
heavy load. It is also useful when walking the bicycle across uneven terrain such as rocky areas.
The intelligent walk assist function activates when an electric shifting system such as XTR, DEORE XT SEIS is connected.
System individually supplies assist power to detect gear position.
“Intelligent walk assist” support rider more torque output in steep climb condition in lower side gears.
“Quick walk assist” function works quickly by holding down SW from any mode.
* The maximum speed up to which power assistance is provided is set by the manufacturer and is conditional on where the bicycle is to be used.
RIDING THE BICYCLE
1. Turn on the power.
• You cannot use the battery immediately after shipment. Refer to ”CHARGING THE BATTERY” (page 27).
•
Do not place your feet on the pedals when turning the power on. A system error may result.
•
Power cannot be turned on while charging.
2. Select your preferred assist mode.
3.
Assistance will start when the pedals start turning.
4.
Change the assist mode in accordance with the riding conditions.
5.
Turn the power off when parking the bicycle.
• Do not place your feet on the pedals when turning the power off. A system error may result.
CHARGING THE BATTERY
You cannot use the battery immediately after shipment.
The battery can be used after charging it with the designated charger.
Be sure to charge it before use. The battery can be used when the LED on it lights up.
The use of a genuine Shimano battery is recommended. If using a battery from another manufacturer, make sure to carefully read the
instruction manual for the battery before use.
DANGER
• Use the Shimano specified charger and observe the specified charging conditions when charging the specified battery. Not doing so may cause
overheating, bursting, or ignition of the battery.
CAUTION
• When removing the battery charger power plug from the outlet or the charging plug from the battery, do not pull it out by the cord.
•
When charging the battery while it is mounted on the bicycle, be careful not to trip over the charger cord or get anything caught on it.
This may lead to injury or cause the bicycle to fall over, damaging the components.
• If the bicycle is stored for an extended period of time immediately after purchase, you will need to charge the battery before using the
bicycle. Once the battery is charged, it starts to deteriorate.
•
Connect to E-TUBE PROJECT and click [Connection check] to confirm whether the battery in use is a genuine Shimano battery or another
brand.
To Next Page
Loading...
