33
Installation/removal
Wiring around the cockpit (clamp band type cycle computer)
` When using cord bands
1. Secure the switch unit's electric wire.
Determine the locations of the cord bands, then secure the electric wire in place along
the handlebar so that there is no slack.
Switch unit
SM-EWE1 (EW-SD50 type)
EW-CB300 (EW-SD300 type)
2. Connect the electric wire to the E-TUBE port.
Wrap any slack around the portion of the handlebar between the cycle computer and
stem prior to connecting.
Stem
To Next Page
Loading...