Shimano Steps E6000 Series - Page 40

37
 Error messages on the cycle computer
WARNING
This disappears if the error is fixed.
< SC-E6000 > < SC-E6010 >
Code
Situation where the
error occurred
Condition for removing
the operational restriction
when a warning is being
displayed
Remedy
W031
The chain tension may
not have been adjusted
or the crank may have
been installed in the
wrong position.
The assist function is
not available.
(Electronic gear shifting
does not function.)
Contact the place of purchase or bicycle dealer.
< SC-E6010 >
List of warnings
Code
Situation where the
error occurred
Condition for removing
the operational restriction
when a warning is being
displayed
Remedy
W010
The temperature of
the drive unit is high.
The level of assistance
may decrease.
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
W011
The traveling speed
cannot be detected.
The maximum speed up to
which power assistance is
provided may decrease.
(Power assistance is provided
up to 25 km/h in top gear.)
Check that the speed sensor is properly installed.
If the situation does not improve, contact the place of
purchase.