82(96)
below 5℃).
5) Anti-freezing setting: anti-freezing switch equipped (setting value 5℃). When
process water temperature is lower than 5℃, the compressor will stop
working.
Attention!
Pump rotating direction should be correct.
Attention!
Before starting the system, make sure that cooling water pump is turned
on. Check the water tank of the chiller. Do not start the machine when
there is no water left in water tank. We shall not be liable for any
damages caused by this reason.
Attention!
In order to reduce the possibilities of machine damage and prolong the
life, start the machine with correct methods.
Attention!
Temperature setting value should not be lower than 5℃. Temperature of
anti-freezing switch and high and low pressure switch is already set
before delivery. We shall not be liable for any damage caused by
unauthorized change of the setting.
Attention!
The compressor can't be started frequently because of its characteristics
(Frequent start will shorten its service life.). Therefore, the compressor
will work about 3 minutes later after turning on the water pump. The
parameter of temperature controller shall not be adjusted freely since it is
already set.
4.3 Machine Shutdown
1) Turn off the compressor.
2) Turn off the pump. (Better to wait for 30 seconds after the compressor
shutdown to ensure that the refrigerant in the evaporator is completely
To Next Page
Loading...
