7(64)
1. General Descriptionp
Read this manual carefully before operation to prevent damage of the
machine or personal injuries.
SMD-H series mould sweat dehumidifiers are designed to remove the moisture
sweat from condensing on the mould surface. Forming of moisture sweat on the
mould surface is due to the use of chilled water for reducing the moulding cycle
time, particularly while moulding of the PET preforms. To bring about the moisture
sweat on the mould surface is because the mould surface temperature is lower
than the dew-point temperature of surrounding air, thus the water vapor comes
into being, then causes corrosion of mould and effects quality of moulding parts as
well as production efficiencies. This series of machine uses honeycomb rotor to
carry out dehumidifying function, which generates a dry airflow with dew-point
ranging from +5℃~-10℃, and ensures the surrounding air of mould remaining in
a low dew-point temperature. It provides constant low dewpoint surrounding air to
the mould surface all year round without being influenced by the change of
seasons.
Model: SMD-500H (Return air Collector is Optional)
To Next Page
Loading...
Need help?
General
