Aoralscan 3_Manual_V1.0.0.30 - 2 -
as needed by using the relevant buttons on the top, bottom and right side.
- Performance
Posterior groove teeth scanning and imaging: Under normal operating conditions, the
scanner can scan and image human posterior alveolar teeth to form a 3D digital model.
Irradiance: Under normal use of the intraoral scanner, the irradiance is not greater than
1mW/cm2.
Accuracy: Under normal conditions, the scanner is used to scan against a standard (e.g., a
plaster standard known to be similar in size to a tooth), obtain its three-dimensional stereoscopic
data, and measure key dimensions to obtain measured values.
Heating of the entrance part of the scanning head: Under normal working conditions, the
intraoral scanner should have heating and anti-fogging function when entering the mouth under
working condition.
- Data interface
USB 3.0, data storage format shall include 3D digital model format .stl and .obj.
Main structural composition
The Scanner consists of Scanner body, scanner head, relay box, adapter, pedestal, USB cable,
software (V1.0), and encryption module. The software carrier is USB flash drive, and the software
release version is V1.0. After the power is switched on, ensure that the relay box and scanner are
powered on. When the power is on, the relay box indicator is green.
Attention
⚫ It is recommended that users copy the software from the USB flash drive to the
computer hard disk before installing the driver.
⚫ Use Nvidia graphics cards to get the highest scanning efficiency.
⚫ Do not insert wireless USB network card in the computer, USB wireless network card
will lead to USB bandwidth occupation, affecting the normal work of the camera.
VI. Product maintenance and care methods, special storage/transportation conditions,
operating conditions.
1) The product does not work in the state as far as possible not to open, the need for water
and moisture.
2) The need to use dustproof cover when sitting.
To Next Page
Loading...
