Shockwave S5 - SERVICE TIPS

13
CLEANING: Rinse your SHOCKWAVE S5 Suspension
Module with fresh water after each use to prevent build up
of salt and corrosion. Treat the suspension module with
Boeshield or similar protectant every month or as often as
possible to prolong appearance and service life. To remove
any dirt/salt build up on seat, use upholstery cleaner as
required.
LEAKS: The shock absorber should hold pressure and only
need to be topped up occasionally. While it is recommended
to regularly check sag and shock settings, the shock
absorber does not require constant pressure adjustment.
SHOCK LEAKS: Check the fill valve to see if debris is
interfering with its operation or perform a simple soap
solution test to identify the source of the problem. If a leak is
found, replace the shock absorber or the fill valve core.
BOLT TORQUE (TIGHTNESS): All fasteners are prone
to becoming loose from sustained high performance use.
SHOCKWAVE recommends that all bolts should be visibly
inspected for signs of being loose after every 125 hours
of use. Always use a thread-locker on threads to prevent
loosening of parts.
Be sure to wash your suspension module properly. Thoroughly wash module
with fresh water and boat or car wash detergent, removing all contaminants
and surface corrosion.
Following CLEANING instructions is the most important way to maximize seat life.
SERVICE TIPS