Shockwave S5 - SETTING UP THE SUSPENSION MODULE

8
Strength of decks and deck mountings is the responsibility of the boat builder or
installer of the seats. SHOCKWAVE assumes no liability for suspension modules
that are incorrectly installed.
Incorrectly installed suspension modules can cause serious injury or death and
can cause damage to the vessel and the seat.
Prior to use be sure to pressurize the shock absorber! Do not operate the seat
without sufficient pressure in shock absorber or serious injury and damage to
the suspension module will result.
To achieve the best performance from the suspension module’s shock absorber, the pressure should be adjusted to attain the
proper sag setting. Sag is the amount the suspension compresses under the occupant’s weight. Sag should be set at 20% of total
shock travel as indicated via red O-ring on shock.
Warranty is void on suspension modules where incorrect installation causes
damage to the module.
DANGER
DANGER
SETTING UP THE SUSPENSION MODULE