Model W1712
***IMPORTANT UPDATE***
Applies to Models Mfg. Since 3/12
& Owner's Manual Printed August, 2003
Phone #: (360) 734-3482 • Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
COPYRIGHT © MARCH, 2012 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
#14867TS Printed in Taiwan
We recently made the following changes to the Model W1712:
• Obtained CSA Certification for the machine.
• Changed the disc dust hood to the correct part number.
These changes do not affect how the machine assembles or functions. In addition to the changes we
made to the machine, we are providing updated information about machine specifications, machine
safety, circuit requirements, electrical grounding, and machine electrical wiring.
Aside from the information contained in this update, all other content in the owner's manual applies
to this machine. For your own safety, you MUST read and understand this update and the applicable
owner's manual. If you have any further questions about this manual update or the changes made to the
machine, contact our Technical Support.
Figure 1. Disc dust hood is part number 6
(changed from part number 70).
For Your Own Safety Read Instruction
Manual Before Operating Sander
a) Wear eye protection.
b) Support workpiece with miter
gauge, backstop, or worktable.
c) Maintain
1
⁄16" in maximum clear-
ance between table and sanding
belt or disc.
d) Avoid kickback by sanding in
accordance with directional
arrows or against rotation of
sandpaper.
To Next Page
Need help?
General
