ShotTrack Vibration Monitors
ShotTrack Pty Ltd Innovation Hub Coffs Harbour NSW 2450 Australia
On the bench
Secure the unit to the surface using the dyno bolt connection
Turn the unit ON
• If wire-break triggering has been selected, then the unit will not arm itself
until the wire-break cable is connected in a shorted condition. It will flash
rapidly RED until a shorted cable is connected
• Walk away
• Unit will set itself after 2 minutes
• An alternate Blue and RED flash will indicate it is waiting for a level trigger.
• A Blue only flash will indicate it is waiting for a wire-break trigger.
After the shot
• The unit will reset itself after recording the data. If the trigger was a wire-break then the unit
resets to Threshold triggering.
• If at any period a Bluetooth connection is made the unit will connect to the application.
• The data just recorded can be downloaded if required.
• The unit can have its operating parameters changed at any point using the Bluetooth
connection
Switch off the unit
Press on/off button until it is illuminated with a solid Blue colour.
To Next Page
Loading...