Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Giant
1. Fasten the centerpiece onto firm trussing (Use a stronger C-clamp fastened onto the Giant).
Leave at least 1 meter on all sides for air circulation.
2. Plug the controller into the center effect.
3. Plug the power cord into a proper electric power supply socket.
Note : Link all cables before connecting electric power
Giant Controller
Fig. 4
1) Reset-button: The Giant will reset and start up after 30 seconds
2) Start-button: When you press start during the movement of the mirrors, the display keeps blinking and the
device is in standby modus. When you press start again, the lamp will work and the mirrors
start moving.
3) Select Programs: Press this button to choose between Program 1-8 or P.
P means the center effect will do all built-in programs after each other.
4) Time Fader: Vary the time between the steps with this fader.
5) Display
6) Pause-button: When you press pause during the movement of the mirrors, the display will read H and the
mirrors will stop, but the lamp keeps burning. When you press pause again, the mirrors start
moving.
7) Audio-button: When you press this button, a small point will appear in the display and the center effect will
be music-controlled.
8) Speed Fader: Use this fader to control the speed of the mirror movement.
To Next Page
Loading...
