3) Turn On Sparkular
4) Parameters setup
Programming SPARKULAR effects according to this manual.
Switch on Sparkular,
2) Turn On Host Controller
Switch on host controller as below.
Swip an RFID card after filling each bag of HC8200. Read the card as show below. SPARKULAR shows time remain if read
successfully. SPARKULAR report E4 when remaining time is less than 10 minutes.
6) Firing
Activate programming effects by press “FIRING” on the host controller.
5) Activate Sparkular machine
After show, please power off Sparkular and host controller. Allow SPARKULAR to cool down before packing. Never
touch the nozzle of SPARKULAR. DANGER OF BURN!
7) Turn Off
15
To Next Page
Loading...
