Why does my Shure BLX have no sound or faint sound?
If your Shure Microphone system has no sound or faint sound, check the following: If the receiver ready LED is on, verify all sound system connections or adjust gain as needed. If the receiver ready LED is off, turn on the transmitter. Also, ensure the batteries are installed correctly and are fresh. Finally, perform transmitter setup.
What to do if my Shure Microphone system has audio artifacts or dropouts?
If you are experiencing audio artifacts or dropouts with your Shure Microphone system, try the following: If the ready LED is flickering or off, change the receiver and transmitter to a different group and/or channel. Identify and remove any nearby sources of RF interference. Replace the transmitter batteries. Ensure the receiver and transmitter are within system parameters. Set up the system within the recommended range and keep the receiver away from metallic surfaces. Ensure the transmitter is in the line of sight from the receiver.
What to do if the receiver LED screen is off on my Shure Microphone system?
If the receiver LED screen is off on your Shure Microphone system, make sure the DC adapter is securely plugged into the electrical outlet and that the receiver is powered on.
General| Transmitter Type | Handheld, Bodypack |
|---|---|
| Frequency Response | 50 Hz to 15 kHz |
| Operating Range | Up to 300 ft (91 m) |
| Transmitter Battery Life | Up to 14 hours |
| RF Output Power | 10 mW |
| System Type | Wireless |
| Operating Frequency | Varies by region (512-542 MHz, 542-572 MHz, 572-602 MHz, 606-636 MHz, 662-692 MHz, 694-703 MHz, 740-752 MHz, 823-832 MHz, 863-865 MHz) |
| Receiver Output Connectors | XLR |
| Modulation | FM |
| Power Source | AA batteries (transmitter), DC power supply (receiver) |
| Dimensions (Transmitter) | Varies by model |
| Weight (Transmitter) | Varies by model |
| Dimensions (Receiver) | Varies by model |
| Weight (Receiver) | Varies by model |
| Audio Output Impedance | 50 ohms |
To Next Page
