Shure Incorporated
10/26
6.
•
•
Attach the magnetic grille to the loudspeaker. The Shure logo is also magnetic, so you can reposition or remove it if
necessary.
Connecting to Power
This device requires Power over Ethernet Plus (PoE+) or PoE to power it.
Use one of the following to provide PoE+ or PoE:
Network switch with PoE+ or PoE
PoE+ or PoE injector device
The PoE/PoE+ source must also be a gigabit device.
Status LED Behavior
LED Behavior Device State
Solid green, then off Device powering on
Green flashing for 30 seconds Device identify
After 4 seconds, green flashing Network reset
Green flashing after 4 seconds, green solid after 8 sec-
onds
Full factory reset
To Next Page
Loading...
