EasyManuals Logo

Shure PGX Wireless Quick Setup

Shure PGX Wireless
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Shure Incorporated
9/21
Multiple System Setup
Use the following steps to ensure the best performance when installing multiple wireless systems at the same lo-
cation.
1. Turn all receivers on and all transmitters off.
Note: Turn on any other digital equipment that could cause interference during the performance so it will be de-
tected during the frequency scans in the following steps.
2. Make sure the group number is the same for all receivers (see Manual Group Selection).
3. Perform a scan using the first receiver.
4. Turn on the first transmitter and sync it to the receiver.
5. Repeat for each system.
Important: After syncing each transmitter, leave it on so that scans from the other receivers will not select
that channel.
Be sure only one transmitter IR port is exposed when synchronizing each system.
Manual Channel and Group Selection (receiver only)
Using the receiver to scan for a channel is the best way to find the best frequency for your system. However, for
multiple system setup, you may need to manually set the group number.
1. Press and hold the channel button.
2. Hold the button until the channel or group display begins flashing.
3. Release and press the button again to advance the setting. At the desired channel or group number, wait for
the flashing to stop. This activates the new setting.
4. Transfer the new frequency setting to the transmitter using the automatic sync function.

Other manuals for Shure PGX Wireless

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shure PGX Wireless and is the answer not in the manual?

Shure PGX Wireless Specifications

General IconGeneral
BrandShure
ModelPGX Wireless
CategoryMicrophone system
LanguageEnglish

Related product manuals