- 71 -
(*MAX Magnification [ ON = 0.05nm, OFF = 0.2nm])
2.9-1.8. Zoom mode
Choosing how to zoom-in/out.
(☞ The default setting is Turbo.)
2.9-2. C-Map (*Only for *C-MAP mode.)
2. 9-2.1. SAT.Image
Setting up the overlay Satellite Image on the C-MAP.
(☞ The default setting is shown.)
2.9-2.2. Font & Symbols
On charts it is possible to set the size of all names and symbols drawn on the charts, selecting
between Normal size and Large size.
(☞ The default setting is normal.).
2.9-2.3. Mixing Level
When the map coverage at the current zoom level does not fill the entire screen, the chartplotter draws
the rest of the map expanding the cartographic information read from, at most, two zoom levels above
the current zoom level. For this reason the map is drawn three times; firstly it draws the two levels
before the current level and then the current level. The area covered by the cartographic data read
from the previous levels is identified by a dotted pattern. When the cursor is moved area not covered
by data of the currents level the chartplotter zooms out to the first level covered by cartographic data.
The default setting is ON.
(☞ The default setting is on.)
2.9-2.4. Perspective View
Chart data may be projected in perspective mode during navigation. This function allows setting the
panoramic View of the chart.
As the upper side of the map is more compressed than the lower side, a wider map area is visible. The
perspective view allows showing more chart information immediately ahead and around the cursor.
(☞ The default setting is off.)
2.9-2.5. Chart Boundaries
To Next Page
Loading...
