- 99 -
General operation
1.GPS
It is available to control and confirm information in GPS receiver.
1.1. Coordinate System
It sets coordinate system of GPS or Loran.
(☞The default setting is GPS.)
1.2. Datum
It shows GPS Datum. WGS-84, which is the worldwide standard is only available.
(☞ The default setting is WGS-84.)
1.3. LAT. Modification
There could be a receiving signal error from satellites. If it is on the latitude, modify in the latitude
modification.
1.4. LOT. Modification
There could be a receiving signal error from satellites. If it is on the longitude, modify in the longitude
modification.
1.5. POG filtering
Step 1(OFF)~59(MAX) the POG Filter. When it is On(over step 1), you can filter the POG of the vessel,
to optimize it.
(☞ The default setting is incorrect every the country.)
1.6. COG filtering
Step 1(OFF)~119(MAX) the COG Filter. When it is On(over step 1), you can filter the COG of the
vessel, to optimize it.
(☞ The default setting is incorrect every the country.)
1.7. SOG filtering
To Next Page
Loading...
