Si-tex SVS-560CF - Page 73

- 73 -
(☞ The default setting is Cross.)
5. Alarm
5.1. Navigation
5.1. 1. Arrival Alarm:
When you approach into the waypoint range, it gives you a notice with alarm.
(☞ The default setting is OFF.)
5.1.2. Arrival Radius:
It is to adjust the range of arrival from your waypoint. If you have a route, it changes to the next
waypoint automatically.
(☞ The default setting is 0.05nm.)
5.1.3. XTE Alarm:
If you are out of the course, it gives you a notice with alarm.
(☞ The default setting is OFF.)
5.1.4. XTE Radius:
It is to adjust the range of the off course.
(☞ The default setting is 0.25nm.)
5.2. Anchor
5.2.1. Anchor Alarm:
It is necessary when your vessel anchors.
(☞ The default setting is OFF.)
5.2.2. Anchor Radius:
If you vessel is out of the range of the anchor, it gives you notice with alarm.
(☞ The default setting is 0.05nm.)
5.3. Interval
5.3.1. Interval Alarm:
It alarms every time you set.
(☞ The default setting is OFF.)
5.3.2. Interval Time