I 12
SIBER DF / INSTALLATION MANUAL
5 INSTALLATION
5.1 GENERALALITIES
The installation must be carried out in accordance with:
• Ventilation quality requirements for rooms (CTE HS3 - RITE 2007).
• Quality requirements for balanced ventilation of dwellings (CTE HS3).
• Requirements for the ventilation of rooms and dwellings (CTE HS3).
• Safety requirements for low voltage installations.
• Requirements for the connection of drains to sewage systems in the rooms and dwellings.
• Any additional requirements of local energy distribution companies.
• Installation instructions for the SIBER DF EVO 1/2 unit.
5.2 POSITION OF THE UNIT
The SIBER DF EVO 1/2 can be fixed directly to the wall or ceiling thanks to the fixing brackets included for this purpose.
Warning! Depending on the weight of the Unit, the installation of the Unit should always be carried out by 2 persons.
For a vibration-free result, a wall or ceiling with a minimum mass of 200 kg/m
2
must be used as a suspension surface. It is not enough
for the wall or ceiling to be made of concrete or metal structures. In these cases, additional measures will be necessary, such as double
plate reinforcement or additional supports. The following points should be kept in mind:
• The Unit must be set level, both in length and width.
• The installation space should be chosen to allow for good condensate drainage, with a trap and a slope for condensate water.
Warning! Ensure that the condensate drain slope is not positive or parallel to the unit.
Warning! The unit is designed for wall or ceiling mounting only. Never install it directly on the floor.
• The installation space must be protected from the weather and frost.
• Ensure that there is sufficient space around and underneath the Unit to ensure that changing or cleaning the filter as well as
maintenance of the Unit can be carried out properly
To Next Page
Loading...