B06 20 243 E-EN
page 13 / 23
09.2010
Installation and Maintenance Manual
CB8-E
CAUTION
The full torque is only generated after bedding in of the linings. The contact pattern must be
minimum 70% for operation.
4.9 Manual release
The disc brake CB8 is provided with an eccentric manual release in series.
The handling of the manual release is carried out as follows:
1. Remove the sidewise cap (figure 7a)
2. Rotate the eccentric shaft clockwise until the indexed position is reached (figure 7b).
The brake is released now.
PLEASE NOTE
For the handling of the manual release a socket key wrench size 19 is recommended.
WARNING
The manual release is spring biassed to realize an auto-kickback functionality. The activated
manual release will jump back in its initial position automatically by spring force, when the
brake is released by solenoid the next time.
3. Push in sidewise cap.
a) Activating manual release b) Activated manual release, view without
protection cover
Fig. 7: Manual release
actuator for
manual
release
To Next Page
Loading...