4 ATS115-ATS115Plus User’s Manual
STOP: it is used to indicate an anomaly that makes impossible the normal operation of the plant.
WARNING: it is used to indicate an anomaly that requires an operation intervention.
ACB (“A Circuit Breaker”): breaker or component for the management of the changeover between
Source A and the Load.
BCB (“B Circuit Breaker”): breaker or component for the management of the changeover between
Source B and the Load.
SOURCE A: it is used to indicate the genset or the mains connected on one side of the ACB.
SOURCE B: it is used to indicate the genset or the mains connected on one side of the BCB.
LOAD: loads electric supply. It can be connected whether to the Source A or to the Source B.
MAINS: public electric supply.
GENSET: electric supply connected to the genset alternator.
DIF (“Digital Input Function”): the code that follows is used to set the digital inputs.
DOF (“Digital Output Function”): the code that follows is used to set the digital outputs.
AIF (“Analogue Input Function”): the code that follows is used to set the analogue inputs.
To Next Page
Loading...
