SICK AR60

Operating Instructions Chapter 3
AR60
8007406/YW24/2016-05-13 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 23
Subject to change without notice
Alignment via Deflector
Mirrors
en
3 Alignment via Deflector Mirrors
= Fit adapter to AR60.
= Mount AR60 in front of sender.
= Switch on AR60.
= Affix a piece of white card or a card covered with Scotchlite (reflec-
tive tape) to the deflector mirror (to make beam array more visible).
= Align sender so that beam array strikes the centre of the deflector
mirror.
= Fix sender in this position.
= Remove card from (first) deflector mirror.
= Affix card in front of second deflector mirror.
= Align first deflector mirror so that the beam array strikes the centre
of the second deflector mirror.
= Fix first deflector mirror in this position.
= Remove card from second deflector mirror.
= Align second deflector mirror so that the beam array strikes the
centre of the receiver optics, if necessary affix white card or a card
covered with Scotchlite (reflective tape).
= Fix second deflector mirror in this position.
= Re-affix card to second deflector mirror.
= Mount AR60 in front of the receiver.
= Align receiver so that the beam array strikes the centre of the
second deflector mirror.
= Fix receiver in this position.
= Switch off AR60.
= Dismount AR60.
= Switch sender and receiver on.
Fig.
7
:
Alignment of a
WSU/WEU26/3 via
deflector mirrors
AR60
AR60
Sender
Receiver
Deflector mirr
or
Deflector mirror