SICK i110

Contents
1 About this document........................................................................ 5
1.1 Scope......................................................................................................... 5
1.2 Additional information.............................................................................. 5
1.3 Symbols and document conventions...................................................... 5
2 Safety information............................................................................ 7
2.1 General safety notes................................................................................ 7
2.2 Intended use............................................................................................. 7
2.3 Requirements for the qualification of personnel.................................... 7
3 Product description........................................................................... 8
3.1 Setup and function................................................................................... 8
3.2 Product characteristics............................................................................ 8
3.3 Symbols on the product........................................................................... 9
3.4 Manual unlocking..................................................................................... 9
4 Project planning................................................................................ 11
4.1 Manufacturer of the machine.................................................................. 11
4.2 Operator of the machine.......................................................................... 12
4.3 Design........................................................................................................ 12
4.4 Integrating into the electrical control....................................................... 12
4.5 Testing plan............................................................................................... 12
5 Mounting............................................................................................. 14
5.1 Safety......................................................................................................... 14
5.2 Converting the actuating head................................................................. 14
5.3 Mounting................................................................................................... 15
5.4 Protection from environmental influences.............................................. 15
6 Electrical installation........................................................................ 16
6.1 Safety......................................................................................................... 16
6.2 Pin assignment......................................................................................... 17
6.3 System connection (M12, 8-pin)............................................................. 17
6.4 System connection (cable entry)............................................................. 18
7 Commissioning.................................................................................. 20
7.1 Testing....................................................................................................... 20
7.2 Recurring technical checks...................................................................... 20
8 Decommissioning............................................................................. 22
8.1 Disposal..................................................................................................... 22
9 Technical data.................................................................................... 23
9.1 Technical data........................................................................................... 23
9.2 Dimensional drawings.............................................................................. 24
CONTENTS
8020543/17K9/2020-06-08 | SICK O P E R A T I N G I N S T R U C T I O N S | i110 Lock
3
Subject to change without notice