8015904/YIT8/2015-03-02 © SICK AG · Germany All rights reserved - Subject to change without notice
10
11. Host Interface Quick Set
The default setting of every IDM scanner is USB HID. If you want to set the
scanner to a different interface please scan one of the codes below.
RS232 Serial
Keyboard Replacement
PS/2 (DOS/V) KBW Standard Mode
PS/2 (DOS/V) KBW Turbo Mode
USB HID Standard Mode ◆
USB HID Turbo Mode
USB Com Port Emulation
12. System Commands
System Information
Master Default
IDM Set Up Link
(needed for configuration via software)
User Default
Factory Default
Save User Default
Factory Default: After scanning” Factory Default”, all parameters will return to factory default value.
Master Default: After scanning “Master Default”, the scanner will remain the pre-set parameters of Host
Interface Selection, Keyboard Interface Control (except Record Suffix; Preamble; Postamble), Serial
Interface Control (except Record Suffix; Preamble; Postamble), and Wand/Laser Emulation Control,
the rest of parameters will be returned to default value.
User Default: After configuring the scanner you can store your configuration via scanning “Save User
Default”. When scanning “User Default” the scanner will load the configurations that you’ve saved before.
Please note when scanning “Master or Factory Default” the user default values will be deleted.
To Next Page
Loading...
Need help?
General