About this document
6 © SICK AG · Germany · All rights reserved · Subject to change without notice 8012471/ZN27/2017-06-09
Operating Instructions
LMS1xx Laser Measurement Sensors
Chapter 1
Simplified device designation in the document
Below, the LMS1xx laser measurement sensor is referred to in simplified form as "LMS1xx".
The exceptions are where distinction between device variants is required because of the
technical features or functions are different. In this case the complete type designation (e.g
LMS10x) is used.
1.2.2 Software versions
Access to the LMS1xx via the SOPAS ET configuration software is password protected.
For details see section “Interactive configuration using SOPAS ET” on page 84.
LMS12x/LMS13x/LMS14x Security and LMC12x/LMC13x VdS (object protection)
Access to these devices via the SOPAS ET configuration software is described in the
document ”Technical Information (installer instructions VdS)”, part no.: 8013749, issue in
English.
Please see section 1.5 “Further information” on page 9.
Software/tool Function State
LMS10x/LMS11x/LMS15x Firmware From V 1.40
LMS12x/LMS173/LMS13x/
LMS182
LMC12x/LMC13x
Firmware FromV 1.11
LMS14x Firmware From V 01.30
LMS10x/LMS11x/LMS15x Device specific software module for SOPAS
ET (device description: *.sdd file)
FromV 01.14.00
LMS12x/LMS173/LMS13x/
LMS182
Device specific software module for SOPAS
ET (device description: *.sdd file)
From V 01.11.00
LMS14x Device specific software module for SOPAS
ET (device description: *.sdd file)
From V 01.30.00
LMC12x/LMC13x Device specific software module for SOPAS
ET (device description: *.sdd file)
From V 01.00.00
SOPAS ET Configuration software From V 02.32 or
from V 3.00 (new
grafical user interface
and functions)
Tab. 2: Software versions