What to do if SICK Accessories display shows '3 and 1 off'?
If the SICK Accessories display shows '3 and 1 off', it indicates that the supply voltage is either missing or too low. To resolve this, check the voltage supply and activate it if necessary.
What to do if SICK LMS5 Accessories displays '1 lights up'?
If the SICK Accessories displays '1 lights up', it signifies that the device is not ready. Check the 7-segment display for an error or run diagnostics using SOPAS ET. If needed, switch the device off and then on again.
What to do if SICK LMS5 displays 'P flashes'?
If the SICK Accessories displays 'P flashes', it means that a firmware update is in progress. Please wait until the firmware update has completed.
What to do if SICK Accessories displays '2 lights up'?
If the SICK Accessories displays '2 lights up', it indicates a slight contamination on the front screen (warning). Clean the front screen to resolve this issue.
What to do if SICK Accessories displays '1 lights up and 2 flashes at 1 Hz'?
If the SICK Accessories displays '1 lights up and 2 flashes at 1 Hz', it means the front screen is heavily contaminated (error). Clean the front screen.
What to do if SICK LMS5 displays '0'?
If the SICK Accessories displays '0', it indicates that the connection to the synchronization master has been interrupted. You should reestablish the connection to the synchronization master.
What to do if SICK Accessories displays 'Each segment flashes once in sequence'?
If the SICK Accessories displays 'Each segment flashes once in sequence', it signifies that the device is powering up. Wait until the device has started.
What does '3' mean on SICK Accessories display?
If the SICK Accessories displays '3', it indicates that the heating is not connected or the temperature is too low, but this only applies to Outdoor devices. Wait until the device has warmed up and check the heating connection.
What to do if the front screen of SICK LMS5 is heavily contaminated (error)?
If the front screen of your SICK Accessories is heavily contaminated and displaying an error, clean the front screen.
What to do if the front screen of SICK Accessories is lightly contaminated (warning)?
If the front screen of your SICK Accessories is lightly contaminated and a warning is displayed, clean the front screen.
Essential safety guidelines to avoid hazards.
Information on potential dangers and safety precautions.
Specific safety information related to laser radiation hazards and compliance.
Procedures and precautions for safe electrical installation.
Introduction to the software used for configuration and diagnostics.
Steps to connect the PC to the LMS5xx via SOPAS ET.
Procedures for setting up the sensor for the first time.
Steps for connecting and verifying the sensor's functionality.
General advice on how to handle malfunctions.
Explains LED status codes indicating errors.
Interprets error codes shown on the 7-segment display.
Information on how to contact customer support for troubleshooting assistance.
General| Brand | SICK |
|---|---|
| Model | LMS5 Series |
| Category | Accessories |
| Language | English |
To Next Page