SICK LMS5 Series User Manual

Electrical installation
76 © SICK AG · Germany · All rights reserved · Subject to change without notice 8013796/ZM63/2017-05-09
Operating Instructions
LMS5xx Laser Measurement Sensors
Chapter 6
6.5 Perform electrical installation on the LMS5xx
Risk of tripping due to cables! Risk of damage to the cables!
Exposed cables on the floor in areas used by people can cause danger.
 Lay all cables such that there is no risk of tripping and all cables are protected against
damage.
6.5.1 Equipment
 Ttool set
 Digital multimeter (current/voltage measurement)
6.5.2 Connection on the USB auxiliary interface and the Ethernet interface of the
LMS5xx
Pre-assembled cables are available to configure the LMS5xx via the USB auxiliary interface
and via the Ethernet interface.
Fig. 43: LMS5xx: USB connection at the auxiliary interface
Fig. 44: LMS5xx: Ethernet connection using the Ethernet cable
DC 24 V
male connector
male connector
USB,
4-pin
USB (Mini-B),
4-pin
Part no. 6042517, 3 m
LMS5xx
PC
LMS5xx
DC 24 V
M12×4-pin
RJ45
8-pin
male connector
Part no. 6034415, 5 m
Part no. 6030928, 10 m
Part no. 6036158, 20 m
male connector
PC

SICK LMS5 Series Specifications

General

Brand	SICK
Model	LMS5 Series
Category	Accessories
Language	English