To Next Page
T
Troy LopezAug 13, 2025
How to fix undervoltage of the SICK S300 Mini supply voltage?
- AAshley NelsonAug 13, 2025
To address undervoltage, check the power supply unit and the connecting cables.
How to fix undervoltage of the SICK S300 Mini supply voltage?
To address undervoltage, check the power supply unit and the connecting cables.
What to do if SICK Scanner has invalid configuration of the EDM?
If there's an invalid configuration of the EDM, check that the machine-side EDM is connected correctly.
What to do if the SICK S300 Mini Scanner supply voltage is missing or too low?
If the supply voltage is missing or too low, check the voltage supply and activate it if necessary.
What to do if SICK S300 Mini Scanner shows a temperature error?
If a temperature error occurs, verify that the device is being operated within the permissible ambient conditions.
Why is my SICK S300 Mini dazzled?
The device may be dazzled by an external light source, such as a headlight, infrared light source, stroboscopic light, or the sun. Remount the device, if necessary.
What to do if the optics cover of SICK S300 Mini is contaminated?
Clean the optics cover.
What to do if the addresses of both the host device and the guest device may have been set to guest in SICK S300 Mini Scanner?
Remove the jumper on the host device and check the connected device and the connection to this device.
What to do if there is a short-circuit in SICK S300 Mini?
Check the wiring for cross-circuits.
General| Type | Safety laser scanner |
|---|---|
| Angular Resolution | 0.5° |
| Number of Scanning Lines | 1 |
| Protection Rating | IP65 |
| Number of Field Sets | 2 |
| Scanning Angle | 270° |
| Wavelength | 905 nm |
| Power Supply | 24 V DC |
| Housing Material | Plastic |
| Output Signal | OSSD |
| Operating Temperature | 0°C to +50°C |
| Response Time | ≤ 100 ms |
| Supply Voltage | 24 V DC |