Figure 12: SOPAS ET layout
1
Process data
2
FIND ME function
3
RESTORE FACTORY SETTINGS
4
Menu
5
Home
6
STATUS
7
Refresh page
8
Edit mode
9
Page contents
ß
Page selection
à
Notifications
á
User mode
The buttons located in the upper right portion of the interface provide global device
configuration. These buttons will be present on every configuration page.
Table 10: Functions
EDIT The EDIT button allows the settings on a given configuration page to be
changed.
The EDIT button will be highlighted light blue when pressed. Pages that can
be configured will be gray until the EDIT mode is activated.
NOTE
1. Click on the button EDIT (on the upper right side)
2. Click on the button RUN (on the lower left side)
3. Change the user mode from RUN into MAINTENANCE
4. Insert the password "main"
5. Now you can change the device configuration
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
41
Subject to change without notice
To Next Page
Loading...
